How to use the vibrating screen scientifically? What are the daily maintenance and precautions for use?
Release time:
Jun 28,2023
When using the vibrating screen, first of all, according to the operating instructions to operate, followed by the usual daily maintenance and maintenance of the vibrating screen should also follow the following methods, so that the vibrating screen screening effect is good, long service life.
When using the vibrating screen, first of all, according to the operating instructions to operate, followed by the usual daily maintenance and maintenance of the vibrating screen should also follow the following methods, so that the vibrating screen screening effect is good, long service life.
1. Before starting the vibrating screen:
(1) should check the coarse net and fine net for damage, such as damage should be replaced in time to ensure the screening effect;
(2) There is also whether each group of beam ring is locked
2. When the vibrating screen is started:
(1) Pay attention to whether there is any abnormal noise. If there is any noise, it may be equipment failure, which needs to be stopped for inspection.
(2) Whether the current is stable
(3) Whether the vibration is abnormal or not
3. After the use of the vibrating screen: clean up after each use.
4. Regularly check the coarse net, fine net and spring for fatigue and damage, and whether each part of the fuselage is damaged due to vibration. The parts that need to be added with lubricating oil must be lubricated.
1. During the period of using the drilling fluid vibrating screen, the motor shall be filled with JS-4 high temperature noise reduction lithium base grease every three months. When injecting grease, foreign matter shall be prevented from entering the oil hole. The oil filling amount shall be 30~40g/each bearing.
2. When the amount of oil in the manual oil pump is reduced, the oil pump will not work normally, and 10# oil should be injected in time.
How to use the vibrating screen scientifically? What are the daily maintenance and precautions for use?
Mud water separation equipment manufacturers
3. When moving and transporting, the screen box should be fixed and placed horizontally to prevent the deformation of the vibrating screen due to severe vibration, thus affecting the service life of the vibrating screen.
4. The thermal relay installed in the electric control box is used for overload and phase loss protection. If the motor and other reasons cause the electric control box to trip and stop, wait for 5 to 10 minutes and open again after troubleshooting.
5. Before use, the vibrating screen should be started for about 10 minutes, and after confirming that there is no abnormal sound and fault, it should be transferred to the working state. When the middle of the vibrating screen is stopped, it should be washed with clean water in time to prevent sundries flowing on the screen and drilling fluid from solidifying and blocking the screen holes. After drilling or stopping not, all parts should be thoroughly cleaned. When cleaning the debris on the screen, do not use sharp objects, so as not to damage the screen.
6, often check the parts of the fasteners, if found loose should be timely fastening. Check the screen fixing bolts in time.
The above is about the vibrating screen operation matters needing attention to explain the knowledge, we hope to help.
Tag:
Recommended News
Share
Hebei Headquarters
Hotline: +86-400-999-3630
Tel: +86-316-5758058 +86-316-5758616
Fax: 0316-8933298
Email: sales@kessolidscontrol.com
Address: Industrial Road 2, Chaobai River Industrial Zone, Dachang County, Langfang City, Hebei Province
